View current and historical firmware versions for your connected MEATER products.
Related Articles & Links
Current Firmware Versions
| MEATER Block | 3.0.10.30 |
| MEATER Plus | *1.6.0.73 (post-purchase update) / 1.6.0.83 (Factory installed) |
| MEATER Pro / MEATER 2 Plus | **0.2.2.43 (Pro) / 0.2.2.39 (2 Plus) |
| MEATER Pro Duo | 3.0.10.11 |
| MEATER Pro XL | 3.0.10.21 |
| MEATER SE | 0.0.2.57 |
| Original MEATER | Not Applicable |
* MEATER Plus firmware versions 1.6.0.73 and 1.6.0.83 are identical—the only difference being if it was installed at the factory or updated via an OTA (over-the-air) update.
** Your MEATER Pro or 2 Plus has firmware matching whichever product name appears in the app. Both versions are identical except for the displayed product name.
Firmware Release Log
Firmware Version 3.0.10.21
Release Date: 27-May-2025
Product: MEATER Pro XL
Release Notes:
- WiFi setup prompts: When MEATER Pro XL is switched on out of range of its original WiFi network, there will now be an automatic prompt to connect to a new network, rather than just staying disconnected.
- Access Point mode for OTA: Since customers can no longer use a hotspot to push a firmware update as of iOS 18, MEATER Pro XL will now create a separate SSID if the update can't be completed on the current network. (PLEASE NOTE: This feature will only work for future updates, and can't be used to update to this firmware version.)
- Sleep mode prevention: If one of the probes is hot, MEATER Pro XL will not go to sleep, in case the probe is being used to monitor temperatures without an active cook.
- Faster probe connection: When a probe is removed from the dock, it should show as connected on the built-in screen more quickly.
Firmware Version 3.0.10.11
Release Date: 6-May-2025
Product: MEATER Pro Duo
Release Notes:
- Charge status: Your probes now show their charging status while docked, displaying either "Charging" or "Fully Charged" in the app.
- LED behavior for unpaired probes: If only one probe is paired to the dock, the unpaired probe won’t trigger a blinking LED when removed.
- LED behavior after firmware update: The right LED now blinks green for 10 seconds after a firmware update, instead of staying solid green.
-
Bug fixes:
- Your MEATER Pro Duo now starts up and works even with less than 25% battery, functioning until fully drained.
- We’ve corrected an issue where LEDs blinked red when a probe was connected; they now blink green as expected.
- Probes no longer disconnect after a firmware update.
Firmware Version 3.0.9.8
Release Date: 3-Mar-2025
Product: MEATER Pro Duo
Release Notes:
- Extended battery life: When fully charged, your device’s battery should last about 5 months when not in use.
- LED behavior when charging: Once your charging dock reaches 95% charge, the LED changes from red to solid green.